Group Kickstarting a High-Bandwidth Software Defined Radio (SDR) Peripheral 140
TwineLogic writes "Many Slashdot readers have been enjoying the availability of $20 USB radios which can tune in the range of 50MHz-2GHz. These devices, while cheap, have limited bandwidth (about 2MHz) and minimal resolution (8-bit). Nuand, a new start-up from Santa Clara, wants to improve on that. Their Kickstarter proposal for bladeRF, a Software Defined Radio transceiver, will support 20MHz bandwidth and 12-bit samples. The frequency range to be covered is planned as 300MHz-3.6Ghz. In addition to the extended spectrum coverage, higher bandwidth, and increased resolution, the bladeRF will have an on-board FPGA capable of performing signal processing and an Altera processor as well. SDR hobbyists have been using the inexpensive receivers to decode airplane data transmission giving locations and mechanical condition, GPS signals, and many other digital signals traveling through the air around us. This new device would extend the range of inexpensive SDRs beyond the spectrum of 2.4GHz Wi-Fi. In addition, the peripheral includes a low-power transmitter which the experimenter can use without needing a 'Ham' license."
Re:300 mhz and up? (Score:5, Funny)